Publicidad
Idiomas disponibles
Idiomas disponibles
3. QUICK START GUIDE
FuturoPunch Pro must be connected to AC power and the ON/OFF
switch should be ON to enable any feature of the machine. Below
are three modes of operation of FuturoPunch Pro.
1.
Bypass Mode:
This operation will allow paper to pass through the FuturoPunch Pro
without being punched.
Step 1: On the LCD user interface screen, press Up or Down key
to enter the Main Menu.
Step 2: Under the main Menu, select Settings by pressing Enter
key.
Step 3: Under settings select Punch mode.
Step 4: Select OFF. This will enable bypass mode.
Step 5: Exit the menu by pressing Up or Down key and selecting
Exit, Ready Bypass should appear.
FuturoPunch Pro is now ready to function in Bypass mode.
2.
Single Punch Mode:
This operation will punch the trail edge of all sheets that pass
through the FuturoPunch Pro.
Step 1: A properly configured die set must be inserted before
running punch mode. See section 4.A for details on Die set
changes and follow the labels on the die set for configuration.
Step 2: On the LCD user interface screen, press Up or Down key
to enter Main Menu.
Step 3: Under the Main Menu, select Settings by pressing Enter
key
Step 4: Select Single Punch. This will enable Single Punch
mode.
Step 5: Exit the menu by pressing Up or Down key and selecting
Exit, Ready Single Punch should appear.
FuturoPunch Pro will now function in Single Punch mode.
3.
Double Punch Mode:
This operation will punch the two rows of holes- One in the middle
of the sheet and the other adjacent to the trail edge of all sheets
that pass through the FuturoPunch Pro.
Step 1: A properly configured die set must be inserted before
running punch mode. See section 4.A for details on Die set
changes and follow the labels on the die set for configuration.
Step 2: On the LCD user interface screen, press Up or Down key
to enter Main Menu.
Step 3: Under the Main Menu, select Settings by pressing Enter
key
Step 4: Select Double Punch. This will enable Double Punch
mode.
Step 5: Exit the menu by pressing Up or Down key and selecting
Exit, Ready Double Punch should appear.
FuturoPunch Pro will now function in Double Punch mode.
FuturoPunch Pro
DOWN
Layout of FuturoPunch Pro LCD User Interface
4.
Die Set Configuration
To configure the Die Set for the desired sheet size that is being
processed see section 8 – Die Set User Manual.
GB
UP
ENTER/
OK
5
Publicidad
