Publicidad
Idiomas disponibles
Idiomas disponibles
C.
Paper Clearing:
When paper is jammed in the paper path of
FuturoPunch Pro the LCD display shows the area
where a sheet(s) is jammed.
Area
If paper is jammed in the Punch Bypass, lift the
paper guide plate located just inside, reach and
remove the jammed paper. To close the paper
guide, raise the handle to unlatch the
mechanism and slowly close it.
If paper is jammed in the downward paper
chute, move the door to the left, reach in and
remove the jammed paper.
If paper is jammed in the left bottom chute,
press the top lever while holding the bottom
lever. This will unlatch the chute; continue to
open the chute until it reached the magnet on
the left side. Reach in and remove the paper.
To return the chute to the closed position,
move it back in the opposite direction until the
latch mechanism is activated.
If paper is jammed in the right bottom chute,
unlatch the chute, reach in and remove any
jammed paper.
If paper is jammed in the upward paper chute,
move the door to the right, reach in and remove
the jammed paper.
Before uninstalling the die set, ensure Area 3
and 5 are cleared of any jammed paper. If there
is no paper found in Area 3 and 5, then
uninstall the die set to remove any jammed
paper.
Interchangable die sets)
Description
(see
Section
4.
Changing
5. USER DISPLAY
Located on the front of the FuturoPunch Pro is a user interactive LCD
panel that provides Messages; Settings and Information relating to the
functions of the punch unit.
Options:
OFF
SINGLE PUNCH
DOUBLE PUNCH
Options:
TRAIL
MID
Messages on the LCD Panel
1.
Ready Bypass
FuturoPunch Pro is ready to bypass, sheets will not be punched.
2.
Ready Single Punch
FuturoPunch Pro is ready to process a punch job, all sheets through
the unit will be punched.
3.
Ready Double Punch
FuturoPunch Pro is ready to process a punch job, all sheets through
the unit will be punch in the middle of sheet and along trail edge of
the sheet.
4.
Running Bypass
This is displayed when Bypass mode is in operation.
5.
Running Single Punch
This is displayed when Single punch mode is in operation.
6.
Running Double punch
This is displayed when Double punch mode is in operation.
7.
Chip tray Full
When the punch container becomes full of waste paper chips, this
message will be displayed.
8.
Chip tray Out
When the punch container is removed or not fully inserted into the
punch unit, this message will be displayed.
9.
Check die
When the Die Set is removed or not fully inserted into the punch
unit, this message will be displayed. When this message is
displayed the punch unit will run in Bypass mode only.
10. Close Door
When the Front door is open or not completely closed this message
the
will be displayed.
11. Paper jam
When a sheet of paper becomes jammed within the punch unit, this
message is displayed. See the section of this manual titled PAPER
JAMS for instructions on how to remove a jammed sheet.
FuturoPunch Pro
Options:
Options:
DEUTSCH
ANSI
ENGLISH
ISO
ESPANOL
FRANCAIS
ITALIANO
Options:
Options:
CC BACKGAGE
MM
CC ALIGNMENT
IN
LCD Panel Overview
GB
7
Publicidad
