Publicidad
Idiomas disponibles
Idiomas disponibles
4. USER OPERATIONS
A.
Interchanging Die Sets:
Are completed without tools and only take seconds to perform
B.
Punch Chip Container:
Easy-to-access chip tray for quick chip disposal
C.
Die Set Storage:
Holds up to 2 spare Die Sets
D.
Punch Bypass:
Short straight-through paper path for unpunched documents
E.
Punch Mode Path:
Wide radius turn can support stocks up to 300g/m
Paper flow and User Interactive sections of FuturoPunch Pro
A.
Your FuturoPunch Pro offers the convenience of interchangeable die
sets, allowing you to economically punch documents for a wide variety
of binding styles. Changing the machine's die sets is both quick and
easy, as the following instructions illustrate:
Note: For advanced Die Set Configuration instructions- See Section 8
Die Set User Manual.
Removing Die Sets from the Machine: The inter-changeable die set
slot of the FuturoPunch Pro is located on the left front side of the
machine.
2
cover
Please note that when using a new die some oil will be present around
the punched holes on the sheet. After punching 25 to 50 sheets the die
will no longer leave oil on the sheets. It is recommended that a short test
print job be run after installing a new die or a die that has recently been
oiled.
B.
The Punch Chip Container for your FuturoPunch Pro is located at the
front of the machine's base. The drawer should periodically be pulled out
and emptied. The FuturoPunch Pro uses a sensor to determine when
the punch container is full. Once the punch container becomes full the
LCD display shows "Chip Tray Full" message and a message also
appear on the printers user interface screen.
FuturoPunch Pro
Interchanging Die Sets:
Step 1: Stop the printer/copier.
Step 2: Open the FuturoPunch Pro access door panel.
Step 3: Securely grasp the die lock handle and rotate it in the
clockwise direction, as indicated in the label near the die lock
handle. This releases the die from the locked position
Step 4: Slide the die set out until it is fully removed, supporting it
with both hands.
Step 5: Properly store the removed Die Set in the Die Set storage
area at the top of the FuturoPunch Pro (keep away from dust, dirt,
accidental falls from the edge of counters, etc.).
Step 6: Select the desired Die Set for your new job and slide it into
the Die Set slot. Push the Die set firmly until the Die stop feature
contacts the round magnet. This is critical in ensuring the proper
position of the die set.
Step 7: Grasp the handle and rotate it in counter-clockwise direction
until the latch is fully engaged, as shown indicated in the label
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING DIE SETS IN YOUR FUTUROPUNCH PRO,
ALWAYS KEEP FINGERS AND OTHER BODY PARTS OUT
OF THE MACHINE'S DIE SET SLOT AND AWAY FROM ALL
AREAS OF THE DIE SET, EXCEPT FOR THE FINGER HOLE
IN
THE
DIE SET. FAILURE TO
PRECAUTIONS MAY RESULT IN INJURY.
Step 8: Close the Access Door Panel.
Step 9: Proceed with your printing and punching job.
Punch Chip Container:
GB
FOLLOW
THESE
6
Publicidad
