Vacmaster Respira UC0501 Manual De Uso Y Cuidado página 27

Should you have any problem(s) with your vacuum cleaner, review the table
below for solutions to minor performance issues.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum will not
power on.
Poor job of dirt
pick-up.
TROUBLESHOOTING
POSSIBLE CAUSE
The plug is not plugged to the
wall outlet.
The power button is not
pressed to start the vacuum
cleaner.
The vacuum body is
overheated.
The motor is damaged.
The hose and accessories
are not installed well.
Dust cup is not installed
correctly.
Full or clogged dust cup.
There is a clog in the hose
or connection hose of the
vacuum cleaner.
The felt filter, primary filter or
the pre-filter needs cleaning.
The felt filter and primary filter
need to be replaced.
The foam filter needs to be
cleaned or replaced.
Be sure power cord plug is fully
plugged into outlet.
Press the power button to start the
vacuum cleaner.
Unplug the power cord and let the
vacuum cool down for 50 minutes.
Call 1-866-384-8432 for assistance.
Check the hose and accessories for
correct installation and ensure they are
snapped firmly in place.
Check dust cup for correct installation
and ensure it is snapped firmly in place.
Empty the dust cup.
Check and remove all clogs. Follow
instructions on page 25-26.
Follow filter cleaning instructions on
page 17-20.
Purchase online at www.vacmaster.
com or call 1-866-384-8432.
Clean or replace the foam filter. Follow
foam filter cleaning instructions on
page 21.
-27-
SOLUTION