baby joy BC10126 Manual Del Usuario página 12

- EN -
14)● Lay the changing table cover on a flat
surface with the back side facing up. Locate
the 2 Curved Connector Bars (Fig. 14a).
Insert the Curved Connector Bars into the
backside of the Changing Table covering
Fig. 14a
(Fig. 14b).
● Attach the Short Bars with the 2 Connectors
to the Curved Connector Bars (Fig. 14c). .
Be sure the clips are faced up during this
preparation on the backside of the changing
table covering (Fig. 14d). Insert both
ends with the push pins into the Curved
Connector Bars. Ensure all pins click into
postion on all 4 connection points (Fig. 14e).
● Close the covering by using the hook and
loop fasteners on the flap. Flip the flaps over
Fig. 14b
the bars and fasten together (Fig.14f).
Fig. 14d
Fig. 14c
Fig. 14e
Fig. 14f
TO SECUR E THE CHA NGINGTABLE TO THE PL AYA RD
IMPORTANT!
When the changing table is on the upper position the changing table must be
secured to the playard frame by using the snap buttons straps or fasteners
provided.
12