baby joy BC10126 Manual Del Usuario página 6

- EN -
ASSEMBLY
TO ASSEMBLE PLAYARD
ATTENTION: Playard must be fully
assembled and securely locked before
installing or using other accessories.
Playard Mattress
1) • Unzip bag and remove Playard frame (Fig.
1). Undo the Fasten straps and set the
Mattress aside.
DO NOT push center down yet.
Fig. 1
2) • Top rails must be fully locked before lowering
center. Pull up one rail at a time, hold one hand on
each side of the rail and pull up sharply, do not pull
from the middle where the center latch release is
located, make sure both tubes latch in place and
each rail is rigid (Fig. 2).
IMPORTANT: The center must be raised while locking
the rails. If one rail will lock but the other side will
not then, unlock the rail by squeezing the release in
Fig. 2
the center and try again.
3) • Once all four (4) top rails are locked in place, push down on the center
handle (Fig. 3a).
The center mechanism automatically locks in place.
IMPORTANT: Test each top rail by pushing down slightly to confirm each is
rigid and securely in place before use (Fig. 3b).
Fig. 3b
Fig. 3a
06