Tascam BD-MP1MKII Manual Del Usuario página 22

Audio Settings
Audio Output
Function
S/PDIF
HDMI
FS Setting
Volume Control
Dolby DRC
* Select Bitstream when using for surround sound connected to an AV amplifier, for example. In order to use bitstream, the connected device must support it.
** This selects the downsampling frequency used for signal processing inside the unit during audio playback. If an audio signal is played that has a sampling frequency
higher than the selected value, it will be converted to the set sampling frequency. PCM signals output from the DIGITAL OUT connector will also be downsampled to the
set value.
Speaker Settings
Function
Configuration
Test Tone
* Lt/Rt is a two-channel downmix output that supports Dolby surround. When played on an ordinary stereo system, the L and R channel balance could be degraded. If this
occurs, select Stereo.
** Trim adjustment overview
Digital full scale (-10dB) is shown as "0" to make adjustment of surround channel speaker volume differences easier.
If trim adjustment is unnecessary, use the default setting (+10).
o When the channel configuration is not 2.x, FL/FR audio signals are output from the ANALOG OUT jacks.
S/PDIF Output Configuration
Function
Configuration
* The maximum audio level will become -10 dBFS only for L/R
22
TASCAM BD-MP1MKII
Options
Bitstream, PCM, Off
Bitstream, PCM, Off
48 kHz, 96 kHz, 192 kHz
Enable, Disable
Off, On, Auto
Options
2.x, 3.x, 4.x, 5.x, 6.x, 7.x
More...
Options
FL/FR, SL/SR, C/SW, SBL/SBR,
L/R (-10dBFS)*
Explanation
This selects the digital audio signal format. *
o When set to Bitstream, a maximum of 6 channels (5.1) of digital
audio can be output. Dolby TrueHD and other 7.1ch formats are
not supported. When set to PCM, the 2 channels of audio speci-
fied in the S/PDIF Output Configuration settings will be output.
This selects the HDMI audio format.
o When set to Bitstream, audio will be output without decoding.
Dolby Atmos and other formats with more than 7.1 channels can
be output. When set to PCM, Dolby TrueHD and other formats
with up to 7.1 channels can be output.
The sampling frequency can be selected.**
o This is not applied to HDMI output.
Volume up/down operations can be enabled or disabled.
Set the dynamic range to Off, On or Auto.
Explanation
The channel configuration can be selected. The speaker size can be
set, and the trim and delay can be adjusted for each channel.
The trim can be adjusted in a range from −10 dB to +10 dB in 0.5dB
increments. **
The delay can be adjusted in a range from 0 cm to 1000 cm in 5cm
increments.
The delay time is 29μsec/cm.
Configuration
2.x: Lt/Rt*, Stereo
3.x: LCR
4.x: LRLsRs
5.x: -
6.x: -
7.x: C+LR+LsRs+LsrRsr
The speaker size can be set, and the trim and delay can be adjusted
while outputting a test tone from the speaker. **
Explanation
The selection items are the same signals that are output from the
analog outputs on the back of the unit.
The selected analog outputs are output from the digital audio out-
put (COAXIAL) connector.
o This setting applies when using PCM. The S/PDIF setting has no
effect when using Bitstream.
Subwoofer selection
None, Single