Publicidad
Idiomas disponibles
Idiomas disponibles
Switch (Fig. 1)
To turn the unit on, depress the side of the dust-protected switch (A)
that corresponds to the symbol "I". To turn the tool off, depress the
side of the switch that corresponds to the symbol "O".
Paper Punch (Fig. 7)
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or accessories. Be
sure the switch is in the OFF position.
A paper punch (M) is provided with your sander to let you perforate
regular sandpaper to make dust collection possible.
TO PERFORATE YOUR SANDPAPER
Install the sandpaper on the tool as instructed in this manual. With
the sander turned off and unplugged, place the paper punch on the
paper so that the tabs at the edges of the punch are against any
two adjacent sides of the sanding pad, as shown. Press the punch
against the pad so that the 8 points penetrate the paper, as shown in
Figure 7. (Press the punch into the pad as far as it will go.) Remove
the paper punch and the paper is ready.
FIG. 7
M
An alternate method of perforating the paper is to securely fasten the
punch to a suitable work surface. Two holes are provided in the punch
for this purpose. Use #8 flat head screws. Press the sander (with the
paper attached) down on the punch.
Dust Extraction (Fig. 1, 8)
Your sander has a built-in vac-adapter (I) which allows either the
supplied dust bag (J) or a shop vacuum system to be connected.
The built-in outlet utilizes the D
compatible with the D
WALT dust extractor.
e
TO ATTACH THE DUST BAG
1. While holding the sander, fit the
dust bag collar (K) to the vac-
adapter (I) as shown in Figure 8.
2. Turn the collar (K) clockwise to
lock the dust bag (J) in place.
TO EMPTY THE DUST BAG
1. While holding the sander, turn
the collar (K) counterclockwise
to unlock the dust bag (J).
2. Remove dust bag from the
sander and gently shake or tap
the dust bag to empty.
3. Reattach the dust bag back onto the outlet and lock into place by
turning the dust bag collar clockwise.
M
You may notice that all the dust will not come free from the bag. This
will not affect sanding performance but will reduce the sander's dust
collection efficiency. To restore your sander's dust collection efficiency,
depress the spring inside the dust bag when you are emptying it and
tap it on the side of the trash can or dust receptacle.
CAUTION: Never operate these tools unless the dust
collector is in place. Sanding dust exhaust may create a breathing
hazard.
26
WALT AirLock connection making it
e
FIG. 8
I
J
K
Publicidad
