Makita DUC252 Manual De Instrucciones página 12

Hold the chain saw away from the tree. Start it and wait
until lubrication on saw chain is adequate.
Bring the spike bumper into contact with the branch to
be cut before switching on. Otherwise it may cause the
guide bar to wobble, resulting in injury to operator.
Saw the wood to be cut by just moving it down.
WORKING WITH THE CHAIN SAW
CAUTION:
• The first time user should, as a minimum prac-
tice, do cutting logs on a saw-horse or cradle.
• When sawing precut timber use a safe support (saw
horse or cradle). Do not steady the workpiece with your
foot, and do not allow anyone else to hold or steady it.
• Secure round pieces against rotation.
Pruning trees
1
► 1. Spike bumper
CAUTION:
• Keep all parts of the body away from the saw
chain when the motor is operating.
• Hold the chain saw firmly with both hands when
the motor is running.
• Do not overreach. Keep proper footing and
balance at all times.
Bring the spike bumper into contact with the branch to
be cut before switching on. Cutting without bringing the
spike bumper into contact with the branch may cause
the guide bar to wobble, resulting in injury to operator.
1
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
If you cannot cut the timber right through with a single
stroke:
Apply light pressure to the handle and continue saw-
ing and draw the chain saw back a little; then apply
the spike a little lower and finish the cut by raising the
handle.
Bucking
2
For bucking cuts, rest the spike bumper shown in the
figure on the wood to be cut.
With the saw chain running, saw into the wood, using
the top handle to raise the saw and the front one to
guide it. Use the spike bumper as a pivot.
Continue the cut by applying slight pressure to the front han-
dle, easing the saw back slightly. Move the spike bumper
further down the timber and raise the front handle again.
When making several cuts, switch the chain saw off
between cuts.
12 ENGLISH