Franke CRYSTAL SM 86 M Manual De Instalación Y Servicio página 5

CL 85 M / CM 85 M / CR 86 M _/F / SM 86 M _/F / SMP 86 M_/F
that ensures complete
disconnection in category
III overvoltage conditions.
Means for disconnection must
be incorporated in the fixed
wiring in accordance with
the wiring rules.
Only use the temperature
Z X
probe recommended
for this oven.
The appliance shall
Z X
not be installed behind
a decorative door in order
to avoid overheating.
Risk of burns!
During use the appliance
Z X
becomes hot. Care should
be taken to avoid touching
heating elements inside
the oven. Children less than
8 years of age shall be kept
away unless continuously
supervised.
Risk of burns!
The end of the door handle may
be hotter due to hot air being
vented.
Always make sure
Z X
that the control knobs
are in the off position when
the oven is not in use.
WARNING: Ensure that the
appliance is switched off before
replacing the lamp to avoid
the possibility of electric shock.
Do not use harsh abrasive
Z X
cleaners or sharp metal
scrapers to clean the oven
door glass/ the glass
of hinged lids of the hob
(as appropriate), since they
can scratch the surface,
which may result in shattering
of the glass.
Do not use steam cleaners
Z X
or direct jets of water.
If the supply cord is damaged,
Z X
it must be replaced
by the manufacturer, its
service agent or similarly
qualified persons in order
to avoid a hazard.
CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal cut-
out, this appliance must not be
supplied through an external
switching device, such as a timer,
or connected to a circuit
that is regularly switched on
and off by the utility.
Proper installation and placement
Z X
Keep children away from the device
and the packaging material.
If the oven is to be permanently connected
to the power supply:
Z X
Ensure that the device is installed only
by the customer service, an electrician
or trained personnel with the appropriate
knowledge/education.
Z X
Ensure that the device is connected directly
to the mains socket. Ensure that no adapters,
no multi-sockets and no extension cables are
used to connect the device.
Z X
Ensure that the device is not exposed to
atmospheric agents (rain, sun).
– 5 –
EN