Descargar Imprimir esta página

Franke CRYSTAL SM 86 M Manual De Instalación Y Servicio página 8

Horno multifunción

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 79
EN
CL 85 M / CM 85 M / CR 86 M _/F / SM 86 M _/F / SMP 86 M_/F
The knobs shown are for illustration purposes only.
Consider the ones on your device.
INSTALLATION
Important: Installation (Fig. 5) must be carried
out in compliance with current standards
and regulations.
It must only be carried out by specialised
and licensed personnel.
Cabinet requirements
9 For fitted units, the components (plastic
materials and veneered wood) must
be assembled with heat-resistant
adhesives (min. 100°C):
unsuitable materials and adhesives
can result in warping and ungluing.
9 The cabinet must allow sufficient room
for the electrical connections.
9 The cabinet in which the oven is fitted
must be strong enough to take the weight
of the equipment.
Z
X
The oven must be securely installed
in the recess.
Z
X
The oven can be installed in a column
cabinet or under the top of a modular unit,
provided sufficient ventilation is guaranteed.
Models CL, CR, SM, SMP
(Fig. 6d)
Fit the appliance in the compartment;
fix the oven to the cabinet with the 4 screws
and the 4 bushings provided, using the holes
prepared in the side panels (Fig. 6d).
0
275
60
240
200
100
180
150
Models CM
(Fig. 6a/6b/6c)
X
X
Measure the width of the cabinet shoulder
(S), which normally can be 16, 18 or 20 mm.
16 mm shoulder: on each fixing bracket
(F) position 2 lugs (T) marked with
the number 16.
18 mm shoulder: on each fixing bracket
(F) position 2 lugs (T) marked with
the number 18.
20 mm shoulder: the 20 mm shoulder
does not require the use of lugs.
X
X
Position the brackets (F) against the cabinet
shoulder and at the bottom on the oven
support top.
X
X
Secure the brackets (F) with the screws (V).
X
X
Position the oven inside the cabinet, open
the door fully and fix it to the brackets (F)
using the 4 screws (U) and the 4 plastic
spacers (D).
Note (applies to all models) (Fig. 6e)
If the oven is to be fitted under a cooktop,
firstly turn the top connection (R) to the right
or left so that the oven fits properly (Fig. 6e).
– 8 –
275
240
200
18

Publicidad

loading