Stadler Form Sam & Sam Manual De Instrucciones página 9

• Do not use this heater in the immediate surroundings of a bath, a shower
or a swimming pool (the appliance is not splash-proof).
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the appliance).
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
Setting up / operation
Note: the operation of Sam and Sam little differs. Pay attention to the prod-
uct description at the beginning of each subsequent point. If no product is
mentioned, the operation applies to both devices.
Note: Make sure that there is always sufficient space between the appli-
ance and the wall or other large objects (> 50 cm). The air flow must not be
blocked by objects of any kind.
1. Having set up Sam / Sam little in the desired position connect the cable
(1) to the household supply socket.
2. First, push the main switch for power supply (3) on the back of the appli-
ance (on Sam little this switch is also the On/Off button).
3. Sam: Switch on the appliance by pressing the On/Off button (7). The
target temperature appears on the display.
4. Sam: The target temperature can be changed from 0 °C (cooling mode) to
35 °C or maximum «Hi» over the buttons (9) «Temperature». The heating
mode is active from 1 ° – 35 °C & «Hi». The digit flashes in configuration
mode. Pushing the «+» button increases the target temperature. Pushing
the «–» button reduces the target temperature. The setting is saved if
no change occurs on the control panel for selection of temperature for
three seconds. The current room temperature is subsequently shown
on the display.
Info: The appliance switches off the heating element when the target
temperature is reached and the temperature indicator flashes on the
display. The ventilator remains switched on for 15 seconds at the lowest
level to cool down the heating element. The current temperature is then
measured approx. every 15 minutes (the fan runs for 1 minute at the
lowest level). The appliance switches on again if the room temperature
recorded drops below the set target temperature.
5. Sam little Thermostat (9): The thermostat allows you a variable tempe-
rature adjustment. Setting: for maximum temperature turn to the left
(«+» symbol), for minimum temperature, turn the control to the right («-»
symbol).
Recommendation: Turn the thermostat control to the left to the maxi-
mum. If the desired room temperature has been reached, turn the ther-
mostat control to the right until the appliance switches off. If the room
temperature drops, then Sam little switches on again automatically with
a slight delay.
6. Sam: Cooling mode: the heating element switches off if the temperature
is set to 0 °C and the ventilator blows cool air out of the appliance. The
LED light (8) changes from red to blue. There is no temperature shown
on the display in cooling mode.