cecotec CONGA ANIMAL Manual De Instrucciones página 46

ENGLISH
Plug it into a wall power socket, the indicator light will turn on.
Turn on the switch located in the lower part of the robot. The green indicator light will turn on.
Note:
- The robot will enter sleep mode after 10 minutes of no operation.
- Make sure the lower switch is on. Otherwise, the robot will not charge and it will show a
red light and a warning alarm.
- For safety reasons, when disconnecting the power switch, the time scheduling will reset.
3. OPERATION
CHARGE
The robot can be charged in the following ways:
- Connect an end of the power cord to the charging base and the other end to a wall grounded
power socket. (Fig. 11 A)
- On Standby or cleaning mode, press the automatic charge button. (Fig. 11 B).
- On Standby or cleaning mode, press the Back Home button.
On/Standby/Sleep/Off
On
- Make sure the power switch in the lower part of the robot is on.
- Press the button
Standby
- Press the button
robot is operating.
- Pulse the button
Sleep mode
- Hold down the button
- The robot will enter this mode automatically when it is 10 minutes without operating.
Off
- Turn off the switch located in the lower part of the robot. We use "O" to turn it off and "I"
to turn it on.
Scheduling
Cleaning scheduling
This robot includes schedule settings for you to customise the cleaning cycles. The robot can
CONGA ANIMAL
46
on the robot or on the remote control to turn on the robot.
on the robot or on the remote control to enter this mode while the
on the robot to enter this mode when the robot is on sleep mode.
on the robot for 3 seconds to enter this mode.