Stihl TS 500i Manual De Instrucciones página 45

Spark Plug
If there is a loss of engine power, the
machine is difficult to start or runs poorly
at idle, first check the spark plug.
Install a new spark plug after approx.
100 operating hours or earlier if the
electrodes are eroded/corroded.
The wrong fuel mix (too much engine oil
in the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose,
which may degrade performance.
Removing the spark plug
Turn off the engine – move the stop
N
switch to STOP or 0
2
Remove the screw (1) and remove
N
the cap (2) – the screw (1) is
secured in the cap (2) to prevent
loss
TS 480i, TS 500i
Remove the spark plug boot (3)
N
Unscrew the spark plug (4)
N
Checking the spark plug
Clean the spark plug if it is dirty
N
1
Check the electrode gap (A) and
N
readjust if necessary – see
"Specifications"
Use only resistor type spark plugs of
N
the approved range. See the
chapter "Specifications" in this
instruction manual
Correct the problems that have caused
fouling of the spark plug:
too much oil in fuel mix;
–
dirty air filter; or
–
unfavorable running conditions, e.g.
–
operating at part throttle.
3
4
To reduce the risk of fire and burn injury,
A
use only spark plugs authorized by
STIHL. Always press the spark plug
boot (1) firmly and securely onto the
spark plug terminal (2).
Do not use a spark plug with a
detachable SAE adapter terminal (3).
Arcing may occur that could ignite
combustible fumes and cause a fire.
This can result in serious injuries or
damage to property.
N
3
2
WARNING
Only use resistor type spark plugs
with solid, non-threaded terminals
English
1
43