Publicidad
Idiomas disponibles
Idiomas disponibles
•
Also make a periodic check on the tray above the compressor and clean it if necessary.
Clean drain hole
To avoid defrost water overflowing into the fridge, periodically clean the drain
hole at back of fridge compartment. Use a cleaner to clean the hole as showed
in right picture.
Switching off the refrigerator
If the refrigerator is to be out of use for some time, turn the thermostat knob to 0 (stop). Then
empty the compartments, disconnect the appliance from the electrical mains, and once it has
defrosted dry any residual moisture which has collected. Leave the door ajar to prevent the
humidity and trapped air from creating unpleasant smells.
Replacing the refrigerator lamp (Section D) (*)
(*) The internal light is a LED type. To replace the lamp, please contact qualified
technician.
Reverse the door (E)
Tool required: Phillips screwdriver, flathead screwdriver, and an adjustable wrench or
spanner.
•
Ensure the unit is unplugged and empty.
•
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit on
something solid so that it will not slip during the door reversing process.
•
All parts removed must be saved to do the reinstallation of the door.
•
Do not lay the unit flat as this may damage the coolant system.
•
It' s better that 2 people handle the unit during assembly.
Follow the images on section E – Reverting door
1. Carefully remove the top hinge cover with a flat screw driver.
2. Unscrew the top hinge with a Philips screw driver.
3. Remove the hole cover with a flat screw driver.
4. Move the core cover from left side to right side. And then lift the upper door and place it
on a padded surface to prevent it from scratching.
5. Unscrew the middle hinge and then lift the bottom door and put it on a soft pad to avoid
scratch.
6. Move two middle hole covers from left to right.
7. Lie down the rear of cabinet on a soft pad. And unscrew the bottom hinge and levelling
foot.
8. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
9. Install the hinge at left side and foot base at right side. Then screw two levelling feet with
their original parts.
10. Move two middle hole covers from left to right.
11. Stand up the unit and put the door on the bottom hinge. Make sure the bottom hinge core
is inserted in the door hole. Then move the hinge hole cover of bottom door from left side
to right side.
12. Install the middle hinge.
English
11
Publicidad
