Permobil ROHO AGILITY Manual De Instrucciones página 5

Important Safety Information - General
Motor Vehicle Transportation Warnings:
- Failure to pay attention to these warnings could result in severe injury to the individual in the wheelchair or to others.
- Whenever possible, transfer out of the wheelchair installed with an AGILITY and into a manufacturer-installed vehicle seat, and use the vehicle's crash-tested
occupant restraint system.
- The AGILITY must be correctly and securely installed, used, and maintained according to the instructions and warnings provided by the wheelchair and
hardware manufacturers.
- Install an AGILITY on a wheelchair so the individual is seated in an upright position and the wheelchair is facing forward during transportation in a motor vehicle.
The AGILITY has only been crash tested on a wheelchair in the forward-facing position per the test information provided in this operation manual.
- The AGILITY must only be used with wheelchair frames that are equipped with securement points specified in ANSI/RESNA WC-4:2017, Section 19 (WC19) or
ISO 7176-19, and that have been successfully crash tested using the methods described in Annex A of WC19 or ISO 7176-19 (respectively).
- The wheelchair with an AGILITY must be used with an effective wheelchair securement system and a properly positioned, crash-tested pelvic and shoulder-belt
restraint, or Wheelchair Tiedown and Occupant Restraint System (WTORS), following the manufacturer's instructions.
- The top of an AGILITY should be positioned as close as possible to the top of the individual's shoulder to provide good support in the event of a crash. The
distance between the top of the individual's shoulder and the top of the wheelchair back should not exceed 6½ in. (16.5 cm).
- ALWAYS safely store AGILITY during transport to avoid damage.
- If the product has been involved in an accident during transport, see the "Maintenance" section in this manual.
- For more information about safely transporting wheelchair users, refer to: http://wc-transportation-safety.umtri.umich.edu/ridesafe-brochure.
AGILITY with Quick Release Hardware has been dynamically tested by a third-party testing facility for use in a motor vehicle and meets all applicable criteria for
wheelchair seating systems proposed in Section 5.1 of ANSI/RESNA WC-4:2012 Section 20 "Wheelchair Seating Systems for Use in Motor Vehicles".
Test results apply to seating systems intended for use by adults and children with a total body mass greater than 23 kg (51 lb, or approximately 6 years of age) who
are transported facing forward in their wheelchairs in all types of motor vehicles.
To determine whether motor vehicle third-party testing has been performed with a specific AGILITY-hardware and other accessory combination, refer to the
operation manual provided with AGILITY, attachment hardware, and other accessory, or contact the equipment manufacturer.
Parts Detail
This manual* references the following package contents: Back Cane
Hardware, Back Shell Hardware, Dual Wrench, operation manual, registration
card
To order replacement parts, contact the product provider or Customer Support.
Back Shell Hardware
Safety Lock
Sliding Height
Adjustment Bar
Triangle Bracket
Width/Height
Adjustment Nuts and
Bolt
Width/Height
Adjustment Plate
ROHO AGILITY Quick Release Hardware Operation Manual
Dual Wrench - To separate and assemble for use as an Allen Wrench:
Latch
Cane Hardware
Double Hook
Upper Pin
Depth/Angle
Adjustment Bolt
Lower Pin
3
* For additional product information, refer to the instructions provided with the
ROHO AGILITY Back Support.
Note: A tape measure or a ruler is recommended but is not included in the
package contents.
1 2
Pivoting Band
Adjustment Cylinder
Bolt
(R) = Right Side
4mm hex key
10mm box end wrench
3
Cane Brackets
L R