Permobil ROHO AGILITY Manual De Instrucciones página 6

Product Specifications
Materials: Back Shell Hardware and Cane Bracket, Zytel; Sliding Height
Adjustment Bar, aluminum; Pivoting Band and Adjustment Cylinder, steel.
AGILITY Quick Release Hardware Weight: 1.75 lb. (0.8 kg)
Accessories Compatible with AGILITY Quick Release Hardware:
ROHO Privacy Shield (non-medical accessory)
Back Shell Hardware Installation
Note: Follow these instructions if the back shell hardware is not yet installed on the AGILITY.
1. Use the box end wrench to loosen and remove the width/height
adjustment nuts. Repeat for both sides.
Place the left (L) and right (R) back shell hardware onto the left (L) and
right (R) width/height adjustment plates.
Right (R) back shell hardware is shown.
2. Replace the width/height adjustment nuts.
Slightly finger-tighten the width/height adjustment nuts. The nuts should
still be loose enough to slide the triangle brackets forward and backward.
Repeat for both sides.
Wheelchair Compatibility
Warnings:
- AGILITY hardware is compatible with many wheelchairs that recline, tilt, or are angularly adjustable up to and including a back angle of 60 degrees. Beyond
60 degrees, AGILITY hardware may be damaged, the AGILITY may disconnect from the wheelchair, and you may be vulnerable to falling and serious injury.
Consult with a clinician or equipment provider to determine if AGILITY hardware is compatible with the wheelchair.
- Rigidizer bars may pose a mounting challenge. See "Troubleshooting". Make sure the rigidizer bar does not interfere with any of the cane hardware
components.
IMPORTANT!
- AGILITY cane brackets should be installed on the back side of the back canes. If needed, they can be installed on the front side
of the back canes, but this will result in a loss of up to 1 in. (2.5 cm) of additional seat depth.
- AGILITY must be sized correctly to the wheelchair and may not fit every wheelchair. Consult with the provider or clinician
providing the equipment to determine if the wheelchair and canes are compatible with an AGILITY.
- AGILITY Quick Release Hardware is designed to be used with most wheelchairs that have circular back canes with diameters
(A) that are no smaller than ¾ in. (2.0 cm) and no larger than 1 in. (2.5 cm). All measurements are approximate.
ROHO AGILITY Quick Release Hardware Operation Manual
Back Shell Hardware:
- Width/Height Adjustment Bolts: M6 x 1.0 x 25mm Carriage Bolt
- Depth/Angle Adjustment Bolt: M6 x 1.0 x 30mm Socket Head Cap Screw
- Cane Hardware Bolt: M5 x 1.0 x 35mm Socket Head Cap Screw
Expected product lifetime: 5 years
4
A
A