Permobil ROHO AGILITY Manual De Instrucciones página 7

Cane Hardware Installation
Warning: DO NOT install the cane hardware while the individual is seated in the wheelchair.
IMPORTANT!
- Follow the wheelchair manufacturer's directions when removing an existing wheelchair back.
- Make sure the wheelchair canes are clean before installing the cane brackets.
- Apply the wheelchair brakes before installing or removing the cane brackets.
Note: Left (L) and right (R) cane hardware is provided. For demonstration purposes, only the left or the right side may be shown.
1. For both sides: Loosen the bolt.
Note: The end of the bolt should be
flush with the adjustment cylinder.
IMPORTANT! The bolt should
NOT disengage from the adjustment
cylinder.
When attaching the cane brackets:
» Place them on the backs of the wheelchair canes.
» Place them at the desired height.
» Make sure the pins face each other.
Cane Brackets
4. With your thumb against the bolt, attach the pivoting band so the narrow part
of the opening is on the groove in the adjustment cylinder.
ROHO AGILITY Quick Release Hardware Operation Manual
Adjustment Cylinder
Bolt
Upper Pins
Lowe r Pins
L (left side)
2. Push against the bolt with your
thumb and pry the pivoting band
away from the adjustment cylinder.
Rotate the pivoting band.
3. Hold the pivoting band against the cane. Rotate the cane bracket until it
presses against the cane.
R (right side)
5. Hold the pivoting band against the cane. Pinch or squeeze the pivoting
band while you finger-tighten the bolt, until the cane bracket is snug against
the cane.
Repeat cane hardware installation on the other side.
5