Water Connections - Carel humiSteam Basic Serie Manual Del Usuario

ENG
Important: before proceeding, disconnect the humidifi er from
the power supply.
Models UE001 to UE018
2
1
3

Water connections:

□ 1. install a manual valve upstream of the installation (to be able
to cut off the water supply);
2. connect the humidifi er to the water supply. On models
□
UE001 to UE0018, use a hose with 3/4''G fi ttings (see par.
11.2 "Technical specifi cations" , compatible CAREL hose: code
FWH3415000). On models UE025 to UE065 connect the hose
with the non-return valve supplied (code FWHDCV0000) to
prevent the water inside the humidifi er from coming into
contact with the mains water;
□ 3. install a mechanical fi lter to trap any solid impurities (to be
connected downstream of the tap);
□ 4 connect a section of non-conductive pipe or hose for draining
(resistant to temperatures of 100 °C (212 °F) and with a
minimum inside diameter of 40 mm/1.6");
5 prepare a funnel to interrupt continuity in the drain line;
□
"UE BASIC" +030220632 - rel. 2.3 - 20.01.2009
2. WATER CONNECTIONS
4
5
6
Models UE025 to UE065
4
2
1
3
4
5
6
Fig. 2.a
□ 6 connect a drain trap to prevent the return of bad odours
(minimum inside diameter 40 mm/1.6");
□ 7 in models UE025 to UE0065: connect a drain hose from the
bottom tank of the humidifi er (this can run into the drain
funnel).
Important : when installation is completed, fl ush the supply hose Important
for around 30 minutes by piping water directly into the drain,
without sending it into the humidifi er. This will eliminate any scale or
processing residues that may block the drain pump and cause foam
when boiling.
10
7