Nilox C3 Manual Del Usuario página 107

Motor overheat
protection
( occurs uniquely
"10"
when the engine is
crew of one
temperature sensor .
Engine temperature
sensor abnormal (
occurs uniquely
"11"
when the engine is
equipped with the
temperature sensor .
Controller current
" 12"
sensor abnormal
Controller
"14"
overheating
protection
Controller
"15"
Temperature Sensor
Abnormal
Abnormal speed
"21"
sensor
Torque sensor
abnormal ( occurs
uniquely when the
"26"
system workout is
equipped with the
torque sensor . )
Abnormal
"30"
communication
2. If you do not ride or ride for a short period , troubleshoot
the faulty part :
1) Replace the motor
2) Replace the controller
1. If you roll during a long time , turn off the system and let
the engine cool .
2. If you don't ride not or don't ride not during a short period
, troubleshoot the part defective :
1) Replace the motor
2) Replace the controller
)
1. Check if the motor cable is properly connected or if the
cable (from the motor to the controller) is damaged .
2. Troubleshoot the defective part:
1) Replace the motor
2) Replace the controller
)
Replace Controller
1. If you ride for a long time , turn off the system and let the
controller cool .
2. If you are not riding or ride for a short period , replace the
controller .
Replace Controller
1. Check if the motor cable is properly connected Or if the
cable (from the motor to the controller ) is damaged .
2. Troubleshoot the defective part :
1) Replace the motor
2) Replace the controller
1. Check if the torque sensor cable is properly connected or
if the cable (from sensor to controller ) is damaged .
2. Troubleshoot the room defective :
1 ) Replace the torque sensor
2) Replace the controller
1. Check if the HMI cable is properly connected or if the
cable (from the HMI to the controller ) is damaged .
2. Troubleshoot the defective part :
1) Replace the controller whether the HMI goes out
automatically after displayed an error code for 20 seconds
.
107