Breville the Paradice 16 Manual De Instrucciones página 23

PROBLEM
The food processor shuts
off during operation
The motor slowed down
during operation
The food processor
vibrates / moves
during processing
INSERT PUSHER flashing
The dicing accessory
is not working
EASY SOLUTION
•
Check whether the message "insert pusher" is displayed on the screen. If so, make sure
the big pusher, the lid and the bowl are correctly locked in place.
•
If the motor overloads, the 'OVERLOAD PROTECTION' icon in the screen will start to
flash. Switch off by pressing the POWER button and unplug the power cord. Allow the
food processor to cool for 30 minutes before resuming.
•
This is normal as some heavier loads (e.g. slicing / shredding cheese) may require
the motor to work harder. Reposition the food in the feed chute and cut the food into
smaller sizes and process using a smaller pusher and continue processing.
•
The maximum load capacity may have been exceeded. Remove some of the
ingredients and continue processing.
•
Make sure the rubber feet at the bottom of the unit are clean and dry.
Also make sure that the maximum load capacity is not being exceeded.
•
This is normal as some heavier loads may require the motor to work harder.
•
Turn the unit off and clear any ingredients that may be caught on the disk, before
continuing.
•
If this occurs while mixing dough – then turn unit off and redistribute the dough
mixture more evenly around the bowl before continuing.
•
Process hard and fibrous foods such as carrots, through the medium or small chute.
•
Make sure that food does not exceed the max line in the food chute.
•
If pusher is fully inserted and this warning flashes on the screen, check that the bowl
and lid are assembled correctly. Bowl handle should be facing the front of the unit.
•
Ensure the accessory kit is inserted as per assembly instructions.
•
Ensure dicing grid is clear from food on top and that it sits locked into the bowl,
flat and stable.
•
Make sure dicing disc is free from wedged ingredients. If this happened use spatula
to clear wedged ingredients.
•
Make sure all dicing parts belong to the same size, i.e. 8mm discs with 8mm grid, etc.
EN
23