Publicidad
Idiomas disponibles
Idiomas disponibles
Please operate the kettle only with the lid on. In addition, water may escape if
operated without the lid. There is a risk of scalding!
1.
Place the kettle on the base.
2.
Select the desired temperature using the "Temperature" button. This is
shown in the display.
3.
After selecting the temperature, briefly press the "Start/Stop/Keep warm"
button. The kettle starts the heating process. The "heating" symbol is shown
in the display.
The kettle stops the heating process to carry out an intermediate measurement
before reaching the target temperature. Please wait until the boiling process is
completed. You will hear a beep at the end.
5.1 Keep-warm function
This function is intended to keep the boiled water warm for a long period of time.
Set the desired temperature using the "Temperature button. If you set 100°C, the
kettle will keep the water between 90°C and 100°C to prevent too much water
from evaporating. To start the keep warm function afterwards, press and hold the
"Start/Stop/Keep Warm" button. As long as the "Keep warm(9)" symbol is shown
in the display, the function is activated.
6. Descaling and cleaning
We recommend to descale the kettle at regular intervals depending upon the
intensity of use. Before cleaning, pull out the power plug and wait until the appli-
ance cools down completely.
The anti-scale filter is located in front of the spout opening. To remove the scale
filter, press the spout from outside to push the scale filter inwards until it is de-
tached. Rinse the filter thoroughly using warm water and then replace it back into
position. When inserting, make sure that it is properly seated.
Please use only commercially available descaling agents based on citric acid to
descale the water container. For the appropriate dosage, please refer to the speci-
fications on the package or insert of the descaling agent. The heating plate should
not be specifically cleaned. Do not use any hard objects on the heating plate.
26
English
Publicidad
