Isotronic 78640 Instrucciones De Uso página 14

Technical data
Battery-operated:
Effective range:
Frequency:
Output frequency: 5 seconds ON and 55 seconds OFF
LED flash interval: 5 seconds ON and 55 seconds OFF
Photosensor: Auto ON for LED
Switch:
Fastening material:4 cable ties, screws
Battery change
1. Unscrew the housing cover.
2. Remove the old batteries from the battery holder.
3. Insert six new micro AAA batteries. Make sure that the polarity is
correct, as indicated on the inside of the bottom of the battery holder.
4. Put the housing cover back on the housing body and screw it back on.
Please make sure that the insulation jacket of the battery is not
damaged or damaged when it is inserted into the battery
compartment. A damage can cause a short-circuit and overheat the
battery.
General information
1. Electric appliances, packaging material etc. should be kept away
from children.
2. Dispose packaging and worn out material correctly and in an
environmentally friendly way.
3. Do only pass on the device including the operation manual.
4. Subject to change of design and technical data without notice for the
sake of constant product improvement.
Safety instructions
Important: Damage caused by not adhering to the operating instructions
is not covered by guarantee. ISOTRONIC accepts no liability whatsoever
for any resulting consequent damages.
- Only operate the device at its intended voltage.
- In case of repairs, only use original spare parts, to avoid serious
damage.
- Repairs or other works, e.g. changing a fuse, etc. may only be carried
out by an appropriately trained, skilled person.
6 x AAA (micro cells, included)
approx. 40 m² (in closed rooms)
12 - 24 kHz +/- 10%
ON-OFF or integrated Vibration switch (automatic
switch-off when the vehicle is moving)