Enphase Energy HCS-D Serie Manual De Instrucciones página 11

The HCS-D Front Panel
The front panel on the HCS-D has six
indicator lights, as shown in Figure 1.
The three colored indicators - left and
right - display status for each of the
two vehicle connectors.
POWER (Amber), indicates that
power is available to the HCS-D.
FAULT (Red), refer to Fault
Conditions in Table 1.
CHARGING (Green), indicates that
the vehicle is requesting a charge and
AC power is currently applied to the
vehicle.
Table 1: Front Panel Indicator Information
Amber
#
POWER
1 off
2 ON
ON
3
ON
4
5 off
6 off
7 off
8 off
9 off
10 off
Red Green
FAULT
CHARGING
off off
off off
ON
off
ON - not
off
blinking
ON - not
off
blinking
1 - blink off
2 - blinks off
3 - blinks off
4 - blinks
off
5 - blinks off
HCS-D User Manual
Figure 1: HCS-D Front
Panel LED Information
Fault Condition
No power to the EVSE. Check circuit breaker.
EVSE has power, not plugged into PEV, or
PEV not requesting a charge.
Charging enabled, power is applied to the
vehicle.
Ground monitor trip, improper grounding or
ground is not present.
PEV Pilot communication out of spec,
disconnect from vehicle and reconnect.
PEV ground fault trip. Check vehicle
connection, disconnect and restart.
Internal EVSE Fault. Disconnect from vehicle, turn power
off and then back on. If fault persists, call for service.
Internal EVSE Fault. Disconnect from vehicle, turn power
off and then back on. If fault persists, call for service.
Internal EVSE Fault. Disconnect from vehicle, turn power
off and then back on. If fault persists, call for service.
Internal EVSE Fault. Disconnect from vehicle, turn power
off and then back on. If fault persists, call for service.
11