cecotec BOLERO AGUAZERO 6100 E Manual De Instrucciones página 95

E3 Water drainage
E4 Temperature sensor
E5 Overflow/leakage
E6 Water leakage
E7 Heating element
WARNING!
If an overflow occurs, turn off the main water supply before calling the official Cecotec
Technical Support Service. If there is water in the base due to overfilling or a small leak, the
water must be removed before restarting the dishwasher.
Before calling technical support service
The following tables may save you from having to contact technical support.
Problem Possible causes
Fuse has blown or
circuit breaker has
The been tripped.
dishwasher
The power supply
does not
is not on.
work
Water pressure is
too low.
Drainage Overflow.
pump does
not stop
Failure of the water drainage system.
Incorrectly installed or clogged drain hose.
Failure of the temperature sensor.
Overflow/leakage of water occurs.
Water leakage occurs.
Abnormal heating.
Possible solution
Replace the fuse or reset the circuit breaker in the
main switchboard of your home. Remove any other
device sharing the same circuit as the dishwasher.
Make sure the dishwasher is on and door is properly
closed. Make sure that the power cord is plugged into
the socket properly.
Check that the water supply is connected properly and
that the water is turned on.
The system is designed to detect an overflow. When it
detects this, it switches off the circulation pump and
switches on the drain pump.
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
ENGLISH
95