JMA NOMAD GO Manual De Usuario página 26

JMA
NOMAD GO
4. MACHINE CHARACTERISTICS
The NOMAD GO machine is a small but highly precise cut-
ting machine for copying flat cylinder lock keys, vehicle keys,
star keys and special keys.
It has one three-sided clamp.
4.1 KEY NOMENCLATURE
1. Key grip
2. Collar
3. Upper shoulder
4. Lower shoulder
5. Notch
6. Blade
7. Shaft
8. Tip
See Figure 3
4.2 MAIN PARTS OF THE MACHINE
The main parts of the machine are listed below:
See Figures 1A-1B
1. Cutter: The cutter is made from high-speed steel (HSS).
2. Tracer: Specifically designed to read the key coding.
3. Clamps: The clamps can be rotated to one of four sides,
enabling different key models to be secured in place. See
Section 4.4.4
4. Knob for releasing/locking the clamp: The clamps are
locked in place using two ergonomically designed knobs.
5. Carriage assembly: This is fitted with two clamps.
6.-7. Carriage assembly control lever and carriage assembly
motion lever.
KEY CUTTING MACHINE
The machine is fitted with two ergonomically
designed levers. The operator MUST hold the
carriage assembly control lever (6) and motion
lever (7) when duplicating keys.
8. Stopper positioning handle: The stoppers are used to posi-
tion and align the key.
9. Tracer depth adjustment control: This is used for depth
adjustment using the knob in centesimal steps.
10. Brush: This is used to remove any burr that may have
formed during duplication.
11. Power switch:
The machine is on when the light is on. 12.
Protective shield: Provides protection from the
cutter.
12. Protective shield: Provides protection from the cutter.
13. Handle: For making it easier to carry the machine.
14. Jack connector: Connect to the power adapter when
needing to charge the battery.
15. Master switch: This switch needs to be ON to operate the
machine.
16. Safety switch protective screen: To prevent accidental use
of the master switch.
17. Battery: For being able to use the machine without nee-
ding a mains connection.
18. Battery charge indicator: Pressing the red circle will dis-
play the battery charge level.
4.3 TECHNICAL DATA
The main technical data is shown below:
Power supply: 29.4 V – 1 A
Battery: Ion-lithium 25.9 V 2500 mAh
Motor: 24 VDC – 150 W
Cutter: High-speed steel (HSS); Ø63x5 (orifice: Ø16)
Cutter speed: 2,100 rpm
Clamps: Four-way steel clamps Carriage movement: On
bearings