Publicidad
Jet nozzle
Cleaning corners,
skirting boards,
(14)
gaps between tiles
and other hard-to-
reach areas
Nylon
Removing soiling
using a minor
brush (12)
mechanical action
Brass brush
Removing stubborn
soiling using a
(13)
mechanical action
Squeegee
Cleaning glass and
(15)
mirror surfaces
Crevice
Cleaning tile joints
brush (17)
Operation
1. Install the required accessories according to the table 1.
2. Plug the power cord plug into a power socket.
3. Press the steam button (7) for 2 seconds to start heating. Wait approx.
15 seconds until two LEDs (8) flash. Press the steam button (7) again to start
operation. Two LEDs (8) light up steadily and steam starts.
4. When the appliance has finished operating, press the steam button (7)
again for 2 seconds. Unplug the appliance from the mains.
5. Wait until it has cooled completely and then wipe the mop with a clean, soft cloth.
12
Assemble the mop (see instructions
above). Attach the jet nozzle (14) to the
body of the steam mop (4) according
to figure G
Attach the jet nozzle (14) to the body of
the appliance (see instructions above).
Attach the nylon brush (12) to the jet
nozzle (14) as shown in fig. H
Attach the jet nozzle (14) to the steam
mop body (4) (see instructions above).
Attach the brass brush (13) to the jet
nozzle (14) as shown in fig. H
Attach the jet nozzle (14) to the steam
mop body (4) (see above). Attach the
squeegee (15) to the jet nozzle (14) as
shown in fig. I
Install the jet nozzle (14) on the device
body (4) (see above). Install the crevice
brush (17) on the jet nozzle (14)
according to figure J
aeno.com/documents
Publicidad
