KPS MT20L Manual De Funcionamiento página 26

• Press the "FUNC." Button to transform to DC measurement.
• Auto range and manual range can be transformed by pressing the "RANGE"
button.
• Connect the probe tip of the meter and probe tip of the test lead (or test clip)
across the power source or be loaded on the two sides under measurement.
• You can get a reading from LCD display. The polarity of the tested terminal
which the tip of the meter connection will be indicated.
NOTE:
• At the little voltage range, the meter will show unsteady reading when test
leads haven't reach the circuit, it's normal because the meter is very sensi-
tivity. When meter touch the circuit, you can get the true reading.
• At the manual range mode, when only the figure 'OL' is displayed, it indi-
cates overrange situation and the higher range has to be selected.
• At the manual range mode, when the value scale to be measured is un-
known beforehand, select the range to the highest position and set down
gradually.
4.8 Medición del voltaje CA
• Rotate the probe socket clockwise to spin out the probe from the meter.
• Insert the black test lead or test clip in the COM jack.
• Set the transform switch at the
• Auto range and manual range can be transformed by putting the "RANGE".
• Connect the probe tip of the meter to one side of the tested circuit and probe
tip of the test lead (or test clip) to the other side.
• You can get reading from LCD display.
NOTE:
• At the manual range mode, when only the figure 'OL' is displayed, it indi-
cates overrange situation and the higher range has to be selected.
• At the little voltage range, the meter will show unsteady reading when test
leads haven't reach the circuit, it's normal because the meter is very sensi-
tivity. When test leads touch the circuit, you can get the true reading.
• At the manual range mode, when the value scale to be measured is un-
known beforehand, select the range at the highest position and set down
gradually.
• Transform to the manual range when use the mV range.
KPS-MT20L • Multimètre type crayon
V range position.
26