Battery Replacement - KPS MT20L Manual De Funcionamiento

KPS-MT20L • Multimètre type crayon
• In the places with many leads and jacks, rotate the sensitivity adjusting knob
in the middle of the transform switch clockwise, set the meter to the lower
detecting sensitivity in order to confirm which one is electriferous.
• NOTE:
• When using AC V detecting function, always set the meter to the highest
sensitivity.
• In this range, even though there is no any sound and light indication, the
meter will still consume electricity.
• There is no auto power off function in this range.
• Always set the power switch to the OFF position when the meter is not in
use.
5. MAINTENANCE

5.1 Battery replacement

Before attempting to open the battery cover of the meter, be sure that the
probe tip of the meter and test lead (or test clip) have been disconnected
from measurement circuit to avoid electric shock hazard.
• If the sign ' ' appears on the LCD display, it indicates that the battery
should be replaced.
• Loosen the screw fixing the battery cover and remove it.
• Replace the exhausted battery with a new one.
• Put the battery cover as its origin.
5.2 Test leads (or test clip) replacement
Full in compliance with safety standards can be guaranteed only if used
with test leads supplied. If necessary, they must be replaced with the same
model or same electric ratings. Electric ratings of the test leads: 600V 10A.
You must be replaced the test lead if the lead is exposed.
6. ACCESSORIES
• Test Lead: Electric Ratings 600V 10A: one piece
• Test Clip: Electric Ratings 600V 10A: one piece
¡WARNING!
¡WARNING!
29