Publicidad
Idiomas disponibles
Idiomas disponibles
Installing your new appliance
Leveling of appliance
For sufficient leveling and air
circulating in the lower rear section
of the appliance, the bottom feet
may need to be adjusted. You can
adjust them manually by hand or
by using a suitable tool.
To allow the doors to self-close, tilt
the top backwards by 0.4" - 0.6"(10
-15mm).
0.4" - 0.6" (10-15mm)
Adjustable
A
bottom feet
Front roller
B
Rear roller
C
A B
C
Adjustable
bottom feet
Door Removal
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator
doors and drawers. If you do not need
to remove the appliance doors,
proceed to "Installing Water Lines" on
page 17. If you need to remove the
doors, continue below.
Tools you will need(Not provided)
Allen Wrench (5/32",4mm)
Philips Screwdriver
Warning
Electrical Shock Hazard
Disconnect power before
removing doors. Reconnect
ground wire before operating.
Failure to do so could result in
death or electric shock.
Keep the refrigerator doors closed
until you are ready to lift
them from the cabinet.
1. Unplug refrigerator or disconnect
power.
2. Using a Phillips screwdriver,
remove the three screws(A)
attaching the hinge cover, and
then remove the hinge cover with
the entire harnesses attached.
Wrench (5/16",8mm)
14
Publicidad
