Mora MRM260N6TSE Guía De Uso Y Cuidado página 19

Installing your new appliance
13 . Take out the lower drawer.
14 . Take out the freezer door.
15 . Move your refrigerator into its final
position, then re-install the drawers
and doors by reversing these steps.
In order to ensure the self-close
mechanism works correctly,
please make sure the doors are
opened more than 90 degrees
when you remove or reattaching
them.
Warning
Installing the water lines
Ice & water dispenser with a filter is
one of the helpful features on your
new appliance. To help promote
better health, the water filter removes
unwanted particles from your water.
Please follow the below instructions
carefully for correct installation.
In order for the ice & water dispenser
to operate properly, a water line is
required.
-the maximum inlet water pressure is
700kPa;
-the minimum inlet water pressure is
207kPa.
Warning
The water connection must be
made by a qualified plumber.
Operation outside the water
pressure range may cause
malfunction, or severe and
damaging water leaks.
Under normal conditions, a200cc
(5.75 oz.) cup can be filled in
about 10 seconds.
If the refrigerator is installed in an
area with low water pressure
(below 30psi), you can install a
booster pump to compensate for
the low pressure.
17