Publicidad
Idiomas disponibles
Idiomas disponibles
8.2 ECO Mode
ECO Mode is a power-saving mode that is enabled by default. When operating on ECO
Mode, the AC / DC output will automatically turn off if the AC70P is bearing low (less
than 40W or the set power) or no load for a while.
Note: When connecting a small power device, disable the ECO Mode for a successful
and uninterrupted charge experience.
In the Setting Mode, use the DC power button to navigate until the ECO icon starts
flashing on the screen. Then, press the AC power button to enable or disable the mode.
8.3 Frequency Switching
The current output frequency (50Hz / 60Hz) is displayed in the lower right corner of the
screen. To change the frequency, access the Setting Mode, press the DC power button
and the frequency starts flashing. Then, press the AC power button to switch between
the available frequency options.
8.4 Power Lifting Mode
Power Lifting Mode allows AC70P to handle high-power resistive loads up to 2000W,
which is disabled by default. In the Setting Mode, use the DC power button to navigate
until the
icon starts flashing on the screen. Then, press the AC power button to enable
or disable the mode.
This mode is particularly useful when using the AC70P with demanding heating devices
such as kettles, electric blankets, and hairdryers. If the screen reads "OVERLOAD" while
operating such devices, activating Power Lifting mode allows the AC70P to tackle these
tasks effectively.
Note: The resistive loads should have a power rating between 1000W and 2000W.
Although the AC70P can handle higher power demands, its actual operating power
remains at 1000W.
8.5 Bluetooth On/Off
In the Setting Mode, use the DC power button to navigate until the
icon starts
flashing on the screen. Then, press the AC power button to turn the Bluetooth on or off.
8.6 AC Charging Mode
The AC70P supports three AC charging modes - Standard, Turbo, and Silent to fit your
specific needs. In the Setting Mode, use the DC power button to navigate until the
or
icon starts flashing on the screen. Then, press the AC power button to enable or
disable these two modes.
17
EN
JUST POWER ON
Publicidad
