Maintenance / Battery
EN
REPLACE THE HANDHELD INTELLIGENT CONTROL
If the handheld intelligent control must be replaced for any reason, the current
handheld intelligent control must be unpaired from the truck, and the new handheld
intelligent control must paired.
Unpair the handheld intelligent control
1. Turn on the truck.
2. Remove the cover to allow access to the display circuit board.
3. Press and hold the white button (item 2) on the circuit board until the red LED
(item 1) turns of.
The current handheld intelligent control is now unpaired from the truck and will
not operate the truck anymore.
Pair a new handheld intelligent control
1. Ensure that the original handheld intelligent control is unpaired from the truck.
2. Press the white button on the display circuit board (item 2) one time.
The LED (item 1) will blink red once.
3. Quickly press any key on the handheld intelligent control.
The LED (item 1) will flash red 4 times to indicate that the new handheld
intelligent control is paired to the truck.
EN84 - Use and maintenance manual