SunPower Maxeon 3 SPR-MAX3-COM Serie Instrucciones De Seguridad E Instalación página 19

SunPower Performance 3 Residen al Solar Panel
(SPR-P3-XXX-BLK)
50
TOP CLAMPS
Moun ng
Moun ng Configura on Diagram
Configura on
Descrip on Front View Back View
Long Side Moun ng,
Rails Perpedincular to
Moun ng Frame
Long Side Moun ng,
Point Supported
Long Side Moun ng,
Rails Parallel to
Moun ng Frame
Short Side Moun ng,
Rails Perpendicular
to Moun ng Frame
(End Mount)
Short Side Moun ng,
Point Supported
(End Mount)
Short Side Moun ng,
Rails Parallel to
Moun ng Frame
(End Mount)
1 In the cases where hybrid moun ng is necessary (combina on of long and short side moun ng), the lowest
design load values should be considered as allowable design load.
2 Test loads are for informa on purposes only, design loads should be considered for the project design.
3 Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
par es, unless there is a formal authoriza on by Maxeon.
©2024 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
Safety and Installation Instructions - Document 001-15497 Rev.AB
180
472 692
1100 mm
1300 mm
1500 mm
1690 mm
Measurement Tolerances are +/-3mm for the Length and Width of the module.
A - Ground Holes (4X Ø 4.2mm)
B - Moun ng Holes (8X Ø 6.8mm)
Moun ng Zone
Test Load Design Load
Loca ons
Downward/Upward Downward/Upward
(distance from corner
(Pa) (Pa)
in mm)
+2400/-2400 +1600/-1600
50 - 180
180 - 472 +5400/-2400 +3600/-1600
472 - 692 +2400/-2400 +1600/-1200
0 - 100 +2400/-1600 +1600/-1067
180 - 472 +3600/-2400
+2400/-1600
80 - 180 +6000/-2400 +4000/-1600
0 - 100 +1600/-1000
+2400/-1500
140 - 240 +2400/-2000 +1600/-1333
MAXEON SOLAR TECHNOLOGIES, LTD.
692 472
GEN 4.3 FRAME PROFILE
SIDE FRAME PROFILE
35 mm
32 mm
4 Bo om flange moun ng.
5 Range indicates posi oning of the clamp and not the rails.
6 Slight bending may occur due to weight of the module.
180
50
B
A
END FRAME PROFILE
35 mm
24 mm
EN