SunPower Maxeon 3 SPR-MAX3-COM Serie Instrucciones De Seguridad E Instalación página 26

SunPower Performance 7 Residen al Solar Panel
(SPR-P7-XXX-BLK)
50
TOP CLAMPS
Moun ng
Moun ng Configura on Diagram
Configura on
Descrip on
Front View Back View
Long Side Moun ng,
Rails Perpedincular
to Moun ng
Frame
Long Side Moun ng,
Point Supported
Long Side Moun ng,
Rails Parallel to
Moun ng Frame
Short Side Moun ng,
Rails Perpendicular
to Moun ng Frame
(End Mount)
Short Side Moun ng,
Point Supported
(End Mount)
Short Side Moun ng,
Rails Parallel to
Moun ng Frame
(End Mount)
1 In the cases where hybrid moun ng is necessary (combina on of long and short side moun ng), the lowest
design load values should be considered as allowable design load.
2 Test loads are for informa on purposes only, design loads should be considered for the project design.
3 Design Load considers 1.5 Factor of Safety, Test load = Design load x 1.5. Product Warranty covers only design
load values. The design loads listed in this table supersede all other loads that may be defined by other
par es, unless there is a formal authoriza on by Maxeon.
©2024 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
Safety and Installation Instructions - Document 001-15497 Rev.AB
270 680
445
1100 mm
1790 mm
A - Ground Holes (4X Ø 4.2mm)
B - Moun ng Holes (4X 9mm (W) x 14mm (L), R4.5mm)
Measurement Tolerances are +/-3mm for the Length and Width of the module.
Moun ng Zone
Test Load Design Load
Loca ons
(distance from corner
Downward/Upward Downward/Upward
(Pa) (Pa)
in mm)
50 - 270 +3000/-2400
+2000/-1600
270 - 445 +5400/-2400
+3600/-1600
445 - 680 +4000/-2400
+3000/-1600
+3000/-2400 +2000/-1600
50 - 270
+2400/-1600
270 - 445 +3600/-2400
+2700/-2400 +1800/-1600
445 - 680
50 - 270 +3000/-2400 +2000/-1600
270 - 445 +3600/-2400 +2400/-1600
445 - 680 +3000/-2400 +2000/-1600
+3000/-1700 +2000/-1133
0 - 323
0 - 100 +2400/-1700
+1600/-1133
100 - 323
+800/-800
+1200/-1200
223 - 323 +2700/-1700 +1800/-1133
MAXEON SOLAR TECHNOLOGIES, LTD.
680 445
270
B
GEN 4.4 FRAME PROFILE
SIDE FRAME PROFILE
30 mm
32 mm
4 Bo om flange moun ng
5 Range indicates posi oning of the clamp and not the rails
6 Slight bending may occur due to weight of the module.
50
A
END FRAME PROFILE
30 mm
32 mm
EN