Publicidad
Idiomas disponibles
Idiomas disponibles
Regulatory Notice
FCC RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated so there is
at least 8 inches (20 cm) between the radiator and your
body. This device and its antenna(s) must not be co-
located or operated in conjunction with any other antenna
or transmitter.
2. IC Notice
The term "IC" before the radio certification number only
signifies that Industry Canada technical specifications
were met. Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
This Class B digital apparatus complies with Canadian
ICES-003.
For products sold in the US and Canadian markets, only
channels 1–11 are available. You cannot select any other
channels.
4 English
IC RADIATION EXPOSURE STATEMENT:
This equipment complies with IC RSS-102 radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated so there is at least 8 inches
(20 cm) between the radiator and your body. This device and
its antenna(s) must not be co-located or operated in conjunction
with any other antenna or transmitter.
General safety instructions
This unit has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 18 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This unit
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this unit does cause
harmful interference to radio or television reception, which
can be determined by turning the unit off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antennae.
• Increase thedistance between the unit and receiver.
• Connect the unit into an outlet or a circuit different from that
to which the receiver is connected.
Publicidad
