Porsche Classic Manual Del Usuario página 6

Charging your vehicle battery
Connecting the clip terminals
1. Connect the PORSCHE Classic battery char-
ger to your vehicle battery by clamping the
red (+) and black (-) clip to the positive and
negative terminals on your vehicle battery.
The (+) and (-) symbols are usually printed directly
on or underneath the corresponding terminal on
your vehicle battery. If there is not enough light to
identify the battery terminals, use the torch func-
tion on the red positive clip.
6
2. Before connecting your charger to the mains
supply, ensure that the clips are connected in
the correct position. If the clips are connected
in reverse polarity, the warning light on the top-
right of the charger will switch on. The built-in
reverse polarity protection function prevents
damage to the battery and charger.
Connecting the ring terminal
cable set
1. Remove the negative battery clip from your vehic-
le battery, and then disconnect the positive batte-
ry clip using a suitable tool.
2. Fully unscrew the hex nuts on the terminal screws
and slide the ring terminals onto the screws.