Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the 2 terminal caps (A) and discard them.
4. Connect the red battery cable to the positive (+)
terminal and tighten the bolt and nut as shown. Move
the terminal cover on the terminal.
WARNING:
battery cable must be connected to the
positive terminal before the black battery
cable is connected to the negative
terminal. This is to prevent sparks and
accidental grounding.
5. Connect the black cable to the negative (-) terminal
and tighten the bolt and nut fully.
6. Apply petroleum jelly on the battery cables to
prevent corrosion.
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use the
lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 34 .
Introduction
WARNING:
safety chapter before you use the product.
To fill fuel
WARNING:
flammable. Be careful and refuel outdoors.
Fuel safety on page 9 .
Refer to
12
A
Risk of sparks. The red
Transportation,
Operation
Read and understand the
Gasoline is very
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector protection
up against the product.
To do a check after the assembly
•
Make sure that all assembly instructions are
completed.
•
Make sure that no remaining parts are in the
package.
•
Make sure that the battery is prepared and charged
correctly.
•
Make sure that the bolts for the seat are tightened
and that the seat is adjusted correctly.
•
Make sure that the tires are correctly inflated.
•
For best cutting results, make sure that the cutting
deck is balanced side to side and front to rear.
Make sure that the tires are correctly inflated for a
balanced cutting deck.
•
Examine the cutting deck and the drive belts. Make
sure that the drive belts are installed correctly
around the pulleys and inner part of all belt keepers.
•
Examine the electrical wires. Make sure that all wires
and connections are safe.
•
Make sure that the freewheel control is in
the "Transmission engaged" position. Refer to
Transportation on page 34 .
•
Make sure that the engine oil is at the correct level.
•
Make sure that the tank is filled with the correct type
of fuel.
•
Make sure that you know the location and function of
all controls.
•
Make sure that the brake system is in safe to
operate condition.
•
Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 8 and To
do a check of the reverse operation system (ROS)
on page 8 .
•
Remove the air from the transmission before
To remove the air from the
first use. Refer to
transmission on page 29 .
CAUTION:
type. Incorrect fuel type causes damage to
the product.
•
Use gasoline of the correct type. Refer to
data on page 36 . For more information about the
fuel, refer to the engine manual supplied by the
engine manufacturer.
•
Do a check of the fuel level before each use and
refuel if necessary.
•
Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.
To do a check of the
Always use correct fuel
Technical
2235 - 002 - 22.09.2023
Publicidad
