Husqvarna TS 154X Manual Del Usuario página 26

1. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 14 .
2. Remove the bolt (A) by turning it counterclockwise
and remove the blade (B).
B
A
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
3. Install the new or sharpened blade and the bolt.
CAUTION:
the blade must align with the star (D) on
the mandrel assembly (E).
4. Torque the bolt to 45–55 ft-lbs (62-75 Nm).
To remove the drive belt from the cutting deck
I A
B
H
G
F
E
1. Park the product on a level surface and engage
the parking brake. Refer to
rearward on page 14 .
2. Put the cutting deck in the lowest position. Refer to
To set the cutting height on page 14 .
3. Remove the dirt or grass around the mandrels and
from the top surface of the cutting deck.
4. Disengage the tension rod (H) for the drive belt from
the locking bracket (I).
5. Remove the screws (A) from the mandrel covers (B).
26
E
D
C
The blades on the
The center hole (C) in
C D
To move forward and
6. Remove the mandrel covers (B).
7. Remove the drive belt from the clutch pulley (D), the
mandrel pulleys (G, E) and the idler pulleys (F).
To install the drive belt for the cutting deck
I A
B
H
G
F
E
1. Install the drive belt around the mandrel pulleys (G,
E).
CAUTION:
correctly in all the grooves for the cutting
deck pulley. Risk of damage to the drive
belt if it is not installed correctly.
2. Install the drive belt around the idler pulleys (F).
3. Install the drive belt around the clutch pulley (H) on
the engine shaft.
4. Install the mandrel covers (B).
5. Tighten the 4 screws (A) fully.
6. Engage the tension rod (H) for the drive belt on the
locking bracket (I).
WARNING:
drive belt is spring loaded. Hold the
tension rod for the drive belt tight and
engage it slowly, risk of injury if the
spring ejects.
7. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 14
To adjust the anti-scalp rollers
The anti-scalp rollers keep the cutting deck in the
correct position on the ground and prevent lawn scalping
in most terrain conditions. The anti-scalp rollers are
adjusted correctly when they are slightly off the ground
when the cutting deck is at the necessary cutting height.
1. Park the product on a level surface and stop the
engine.
2. Adjust the product to the necessary cutting height.
To set the cutting height on page 14 .
Refer to
C D
Put the drive belt
The tension rod for the
2235 - 002 - 22.09.2023