Descargar Imprimir esta página

YATO YT-82555 Manual Original página 19

Bomba de piston para spray de pintura hvlp

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 78
EN
Apply several thin layers of coating material instead of one thick layer. Before applying the next coat, leave the previous one to dry
slightly, follow the instructions supplied with the spray agent.
CLEANING AND MAINTENANCE
Warning! Do not use fl ammable materials for cleaning and maintenance.
Unscrew the container and clean the interior and exterior of the suction pipe using diluent designed for the coating material im-
mediately after fi nishing work. Then fi ll the tank with the diluent intended for the coating material and start spraying it onto the test
surface. Stop spraying when the clean diluent is coming out of the nozzle.
Stop spraying, turn off the device, unplug the power cord from the socket, and unplug the hose from the gun and the compressor
housing. Then remove the container, empty the rest of the thinner and dry it. Disassemble the nozzle and drive and check the
condition of the gaskets. They can be lubricated with a thin layer of silicone grease or technical petroleum jelly. Unscrew the nozzle
mounting nut and thoroughly clean all components (XI) with a soft cloth and diluent suitable for the respective coating material.
Remove the suction pipe and check for residual coating material and clean it with a soft plastic bristle cleaner if necessary. Check
the condition of the container gasket.
There is an inlet air fi lter in the compressor housing. Press the clip (XII) slightly and remove the air fi lter cover. Remove the sponge
fi lter under the cover from the housing and clean it. Clean the fi lter with a jet of compressed air of not more than 0.3 MPa. If the
fi lter is still dirty after cleaning, replace it. After cleaning the fi lter, mount the fi lter and the rear part of the housing in place. Do not
use the spray gun without the fi lter installed, as this may damage the spray gun.
Leaving the spray gun dirty will cause drying out the coating material inside the product. This can lead to irreversible damage to
the gun.
Clean the outer parts of the product with a soft, damp cloth and then wipe dry.
Caution! It is forbidden to clean the spray gun by directing a jet at it or immersing it in water, diluent or other liquid. It is forbidden
to use sharp objects and/or abrasive cleaning agents to clean the guns.
Transport and storage
The unit has a space in the housing for placing a coiled hose and a gun. The hose should be rolled up so that its cross-section is
not deformed. The gun should be placed with the tank in a place prepared in the housing (XIII). The device has a sliding handle
that makes transport easier. The length of the handle can be changed by pressing and holding the button located in the handle
holder (XIV). During operation, the handle should be set in the lowest position so that it does not interfere with the operation of
the gun.
Keep the product out of the reach of unauthorised persons. The storage area should be protected from precipitation and direct
sunlight. Ensure good ventilation in the storage area. Store the product in the working position with the hose disconnected from
the gun and the compressor.
O R I G I N A L
I N S T R U C T I O N S
19

Publicidad

loading