Giordani CRONO Manual De Instrucciones página 40

of the backrest. Store the buckle
in the storage compartment of
the safety seat. Check that the
headrest moves to the highest
position freely. Replace the fabric
smoothly.
I-SIZE UNIVERSAL(100-150 cm):
CONNECTORS+- THREE-POINT
OPTION 2: THREE-POINT
• This ECRS seat is installed in the
forward facing position and is
suitable for children with a height
of 100-150 cm. It has 1 adjustable
sitting position.
• Conceal the five-point harness and
pads before using the ECRS seat.
• Suitable for models with ISOFIX
systems compliant with ECE R14
and with three-point seat belt/
seat belt with a retractor compliant
with ECE R16.
• Don't use force-bearing points
without markings
39. R etract the support leg and
store it in the base.
40. Press the ISOFIX button at the
bottom of the seat forward and
backward with your hand, extend
the ISOFIX connectors on both
sides to the maximum length,
press the end of the ISOFIX, and
it will not be retracted.
41. I nsert the ISOFIX connectors
R388_CRONO_(KX 115)_Libretto_v5ok.indd 40 R388_CRONO_(KX 115)_Libretto_v5ok.indd 40
OPTION 1: ISOFIX
CAR SEAT BELT
CAR SEAT BELT
ATTENTION:
I-SIZE (100-150 cm)
(forward facing)
of the child car seat into the
corresponding ISOFIX anchors
of the car, you will hear them
lock with a click and the display
window will show the green
symbol. If the ISOFIX connectors
are inserted incorrectly, the
window will display the red
symbol.
42. P ush the child car seat firmly
against the backrest of the
vehicle seat. Shake the seat
from side to side to make sure it
is securely attached.
43. A djust the child car seat in
the forward facing position,
suitable for children with a
height of 100-150 cm, 1 reclining
position is available.
44. I nstall the SIP and, once the
safety seat has been installed,
close the car door.
45. Place the child in the safety seat,
adjust the headrest to the correct
position, with the guide hook
slightly higher (1-2 cm) than the
child's shoulders, then pass the
diagonal seat belt through the
green guide under the headrest.
The lap belt must go through
green hook and both seat belts
should pass through the green
guide under the armrest. Click
the metal parts into the buckle of
the car seat belt. Check that the
belt is not twisted and tighten the
seat belt by pulling the diagonal
belt upwards. Check that the
lap belt is positioned as low as
possible, across the thighs and
40
no
fo
m
Don'
using
THR
46. Re
it
47. Pl
ad
po
sl
ch
di
gr
Th
gr
sh
gu
m
ca
is
be
up
is
ac
th
48. Pr
SI
be
Do
w
49. In
ch
pa
sp
as
Don'
using
10/11/23 14:11 10/11/23 14:11