AENO DI2 Manual De Instrucciones página 16

Tap button (3) to turn on the device. The operating mode indicator on the
irrigator panel (5) will light up. Use the mode selection button (4) to select the
desired mode.
Device operating modes
 "Beginner" – gentle cleaning for sensitive teeth and gums. Also
recommended for first-time users of the device;
 "Light" – uniform cleaning before moving on to an intensive one;
 "Medium" – daily standard cleaning, plaque removal;
 "High" – intensive cleaning, thorough oral care;
 "Spot" – removal of food debris from interdental spaces, prevention of tartar
formation.
NOTE. The "Spot" mode does not have its own indicator on the mode selection
panel (5). When the device is in this mode, all four panel indicators glow.
By default, the device is set to "High" operating mode the first time it is turned
on. Subsequent single taps of the mode selection button (4) alternately change
the operating modes, which are displayed on the panel (5). The last selected
mode is saved in the device memory and will be automatically selected the
next time the irrigator is turned on. After selecting the mode, move on to device
operation.
Device operation
Direct the nozzle outlet (1) into your mouth cavity. Tap button (3) to turn on the
device. Move the nozzle outlet (1) along the gum contour as shown in figure h.
During cleaning, you can switch the operating modes using button (4). Having
finished the cleaning, tap button (3) to turn the device off. If the device is not
turned off after use, it will automatically switch off after no more than two (2)
minutes. After each use, it is required to rinse the device and the used nozzles
as described in the "Maintenance" section ("Daily care").
NOTE. It is not recommended to use nozzle (15) in "Spot" mode to avoid injury
to the periodontal pockets.
16 aeno.com/documents