Publicidad
Idiomas disponibles
Idiomas disponibles
English • Owner´s manual
Do not operate this pressure washer if any of the parts are damaged or missing until the part is
replaced. Using this product with damaged or missing parts can cause damage to the machine or
result in serious injury or death.
Unpacking
1. Remove the high pressure hose from box.
2. After the high pressure hose has been removed, carefully open product by cutting down the sides of
the box.
3. Remove the product, parts, and all accessories. Make sure all items listed on the packing list are
included and not damaged.
Install the wheels
Install the wheel assembly onto the frame sleeve
on the side of the fuel tank. The wheel spring
button is aligned with the hole in the housing
and pops out.
Install Handle
Install upper frame (handle) onto the lower
frame by sliding the handle over the two upright
tubes on the lower frame and pressing down
firmly until the handle is seated and the two
detent pins snap in place.
Attaching the Spray Gun
• Screw the spray wand and the trigger handle together until they are secure.
• Insert the inlet coupler of the spray hose into the threaded fitting on the high pressure spray gun and
thread the black nut on by turning clockwise until it is hand tight.
25
Publicidad
