Publicidad
Idiomas disponibles
Idiomas disponibles
English • Owner´s manual
Adding / Checking Engine Oil
• Place pressure washer on a level surface.
• Remove one or both of the crankase dipsticks
to ensure you do not overfill the engine.
• Carfully add between 520ml of 4 cycl engine oil
(SAE10W30) to empty reservoir until oil reaches
the outer edge of the oil fill hole (crankcase
dipstick hole).
• Be sure to replace both dipsticks before at-
tempting to start the engine.
• To check oil, set pressure washer on a level
surface, wipe dipstick clean, then reinsert
dipstick without re-threading.
Adding Fuel
• Set pressure washer on a clean and level surfa-
ce in an area that is well ventilated.
• Remove fuel cap.
• Insert a funnel into the fuel tank and carefully
pour gasoline into the tank until fuel level rea-
ches 1 1/2 inches below the top of the neck
CAUTION! Oil must be added to unit prior to
first use.
CAUTION! To avoid spillage, do not overfill fuel tank as gasoline expands.
Connect High Pressure Hose to Pump
• Attach end of high pressure hose to the high
pressure outlet on pump.
• Follow the same procedure with opposite end
to attach high pressure hose to spray wand.
Connecting Garden Hose to Pressure
Washer
• Inspect inlet screen and remove any debris.
• Connect hose to water inlet and tighten by
hand, or connect the quick link male to the
inlet and quick link female to the hose. There
must be a minimum of 10 feet of unrestricted
hose between pressure washer and faucet or
shut off valve.
• Turn on water.
• Purge the system's pump of air by releasing the
safety and squeezing the trigger of the spray
gun.
26
Publicidad
