Goodyear GY 3300PW Manual De Instrucciones página 28

English • Owner´s manual
• Holding the machine with your hand, pull
the recoil handle (starter cord) slowly until
resistance is felt, then pull rapidly. Squeeze
the Gun trigger and release the pressure after
every failed attempt to start the pressure
washer (This will reduce the back pressure).
• Let the engine run for several seconds and then
gradually slide the choke lever to the RUN
position. Once the engine is warm up, you can
totally slide the choke to the RUN position.
WARNING! Pull cord recoils rapidly and pulls arm towards engine faster than you can let go
which could result in injury.
• Always relieve pressure from spray gun before pulling starter cord, including every failed attempt to
start engine.
Stopping Pressure Washer
• Turn the on/stop switch to the OFF position.
• Turn the fuel valve to the OFF position.
• Turn off water and squeeze the trigger handle
to release all water pressure.
Using the Spray Gun
• Flip the lock tab behind the trigger up or down until it clicks to apply or remove the safety. Pull back on
the trigger to begin operating pressure washer.
• To stop water flow, release trigger.
1. Slot
WARNING! Kickback forces result from pressing the trigger! Therefore, always hold the spray
gun with both hands! Pay attention to safe posture! Improper handling can lead to injuries!.
Using Spray Nozzle
• To connect or disconnect spray tip, pull back on the quick-connect collar. Insert or remove spray tip
then release collar.
• When spray tip is connected, pull on the spray tip to make sure it is secured.
28
1
2
2. Lock out
3
3. Trigger