Publicidad
Idiomas disponibles
Idiomas disponibles
4
Slide Latch Housing Retainer
tight to Head Track
Retainer. DO NOT
overlap Head
Track
Retainer.
Position Latch Housing Retainer to side
jamb, butting up tight to Head Track Retainer.
Drill 1/8" holes - 3/4" deep, clear debris, apply sealant in holes, and fasten with #8 x 3/4" Stainless Steel Screws.
1
st
Position Latch Housing Retainer tight to Head Track Retainer and snap into kerf using a rubber mallet and wood block.
9 2 0 5707
2
nd
Position Latch
Housing Retainer.
NOTICE
·
Protect surfaces from
tool contact. Failure to
do so could result in
surface marring or
product damage.
NOTICE
·
DO NOT drill deeper
than 3/4" into side
jamb. Doing so will
result in product
damage.
Drill 1/8" holes,
3/4" deep using
Latch Housing
Retainer as
a guide.
2
nd
14
200/400 Series
#8 x 3/4"
Stainless
Steel Screw
1
st
3
rd
Snap into kerf,
fully seat using a
rubber mallet and
wood block.
Position
Latch
Housing
Retainer.
Apply Sealant
in holes and
fasten Latch
Housing
Retainer with
#8 x 3/4"
Stainless Steel
Screws.
A-Series
A-Series
No Fastener Required
Publicidad
