Cub Cadet Pro Z SurePath Manual Del Operador página 12

Check the results of any adjustments to the conditions described above. Repeat any
adjustment procedures as required until all conditions are met.
This machine is equipped with an adjustable seat, which includes a retractable seat
belt assembly and an Operator Presence Sensor (OPS). The OPS, in the form of a
switch, is integrated into the seat bottom and is connected to the machine electrical
system. The OPS must be connected to the electrical wiring harness.
The seat can be adjusted forward and backward, the armrests can be adjusted up
and down, and air ride adjustment, a lumbar support, can be adjusted. The seat can
also tilt forward and backward.
NOTE: The seat base must be secured by the latch, otherwise, the seat assembly
could tilt forward.
Seat Position
To move the seat forward or back, locate the seat adjustment rod (a) under the seat.
Push the rod to the left, slide the seat forward or back into the desired position and
release the rod when the seat is in the desired position (Figure 15).
Seat Tilt
The seat tilt is controlled by the knob on the left of the seat. Turn the knob rearward
to tilt the seat back, turn the knob forward to tilt the seat forward (Figure 16).
a
Figure 15
Figure 16
SET-UP
Seat Lumbar
To vary the lumbar support move the lever on the right of the seat up and down
(Figure 17).
Seat Arm Rest
To adjust the height of the arm rests, lift the arm rest and rotate the knob under the
arm rest right or left to increase or decrease the height (Figure 18).
Seat Air Ride
The air ride can be adjusted up or down using the height adjustment lever (a) on the
front of the seat. Press the lever to the left (+) to raise the height of the seat and to
the right (-) to lower the height of the seat (Figure 19).
12
Figure 17
Figure 18
a
Figure 19