Cub Cadet Pro Z SurePath Manual Del Operador página 39

Problem
SurePath Auto Steer System
NOTE: SurePath Auto Steer system issues
may be resolved by turning the mower off,
waiting 10 seconds and then turning the
mower back on.
PRODUCT CARE
Cause
1. Indicator/Warning Lights do not flash blue after
key is turned on.
2. Indicator/Warning Lights do not go solid green.
3. Mower is in an open area but Indicator/Warning
Lights stay flashing green with periodic red.
4. Mower is in an open area but Indicator/Warning
Lights stay flashing green (no periodic red).
5. Indicator/Warning Lights flash yellow when you
press a button.
6. Indicator/Warning Lights flash yellow while in
Auto Steer Mode.
7. GPS indicator is ON but SurePath Auto Steer
Mode will not engage.
8. Indicator/Warning Lights flash red while system
is being used in SurePath Auto Steer Mode.
9. Indicator/Warning Lights flash red.
10. SurePath Auto Steer Mode leaves uncut areas
between mowing passes.
11. SurePath Auto Steer Mode is overlapping too
much between mowing passes.
12. SurePath Auto Steer Mode needs to be disabled. 12. To disable the SurePath Auto Steer Mode:
1. Check fuses. Replace with same rating fuse, if necessary.
2. Move away from trees and buildings. Ensure nothing is blocking
the GPM.
3. Check for strength of cellular signal.
4. Verify SurePath Auto Steer subscription as follows:
• Make sure annual subscription has not expired.
• Check if mower has been moved out of the state(s) where
SurePath Auto Steer subscription was activated.
• Contact an authorized service dealer if the above items do
not resolve.
5. Review the following:
• SurePath Auto Steer system is not ready. Wait for GPS indicator
to be solid green.
• Mower has not traveled minimum recommended distance to
allow setting of the mowing line. See Setting the Mowing Line
(SurePath Auto Steer Mode).
• Invalid reset of mowing line. See Clearing the Mowing Line
(SurePath Auto Steer Mode).
6. Mower speed too fast. Reduce speed.
7. Resume use in manual mode and contact an authorized service
dealer to review active faults.
8. Verify the following:
• If mower is under a tree or near a structure move to an open
area and verify nothing is blocking the GPM.
• Check for strength of cellular signal.
• Resume use in manual mode and contact an authorized service
dealer to review active faults.
9. Resume use in manual mode and contact an authorized service
dealer to review active faults.
10. Turn Cutting Width knob counterclockwise to increase
mowing overlap.
11. Turn Cutting Width knob clockwise to reduce mowing overlap.
• Remove GPM fuse (labeled F5:GPM in the fuse box located
under the operator's seat) to disable SurePath Auto
Steer system.
• Contact an authorized service dealer.
39
Remedy