Publicidad
Idiomas disponibles
Idiomas disponibles
Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself in a ± 4°
range and will project upper or bottom horizontal 360° or/and
2 vertical 360° green beams.
1. Remove the laser level from the case and place it on a
solid, flat, vibration free surface or on a tripod.
2. Push the ON/OFF button. The laser level will project a 360°
lower horizontal beam. The battery indicator (b) will turn
on. The leveling indicator (e) will start to blink slowly.
3. Chose the needed laser beams using the selector buttons:
a. Horizontal beam selector (f) operating by cycle: Bottom
beam => upper beam => no horizontal beam
b. Vertical beam (g) operating by cycle: V1 beam =>V1 +
V2 beams => no vertical beams.
4. Leave the device steady until the leveling indicator (e)
stops blinking – the laser beams is leveled now and ready
for use.
5. If the initial inclination of the laser level is beyond ± 4° and
the automatic mode is activated, the leveling indicator will
not stop blinking. In this case reposition the laser level on a
more level surface.
10
OPERATING INSTRUCTIONS
Publicidad
