Tool Use And Care; Service; Specific Safety Rules - ENAR VGR6 Manual De Instrucciones

3.4 TOOL USE AND CARE

USE clamps or other practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against your body is unstable and may lead to loss of control.
DO NOT FORCE tool.
USE the correct tool for your application. The correct tool will do the job better and safer at the rate
for which it is designed.
DO NOT USE tool if switch does not turn it on or off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
DISCONNECT the plug from the power source before making any adjustments, changing
accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool
accidentally.
STORE idle tools out of reach of children and other untrained persons. Tools are dangerous in the
hands of untrained users.
MAINTAIN tool with care. Properly maintained tools, with sharp cutting edges are less likely to bind
and are easier to control.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools.
USE only accessories that are recommended by the manufacturer for your model. Accessories that
may be suitable for one tool, may become hazardous when used on another tool.

3.5 SERVICE

Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

3.6 SPECIFIC SAFETY RULES

For the proper operation of the motor, MAKE SURE that operators have been instructed in the
proper management of this machine.
The motor SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
Before connecting the motor to the electrical system, MAKE SURE that the voltage and frequency
coincide with the ones stated in the characteristics equipment plate, located in the top part of the
plastic housing.
ENSURE that all frame screws are tight before starting work.
AVOID the flattening of the cable by heavy machinery with could cause breakage.
DO NOT CONNECT the flexible shaft to the motor when this is working.
DO NOT OPERATE in the motor shaft when this is working and without transmission.
DON NOT WORK with transmission or poker in bad conditions, the motor overheats.
DO NOT WORK with the plastic housing broken.
DO NOT PERMIT untrained personnel to operate the motor or connections.
MAINTAIN free ventilation of air.
KEEP the motor in a clean and dry area.
MAKE SURE that the electrical cable is with the proper section and functioning properly
BEFORE DOING any type of repair, DISCONNECT the motor from the electrical system.
WHEN CONNECTING to a generator, MAKE SURE that the out tension and frequency is stable,
right, and has the proper power, (the converter's feeding voltage should not vary more than ± 5% as
stated on the motor's plate).
PETROL ENGINE-ELECTRIC MOTOR-FLEXIBLE SHAFT AND POKERS
VGR6, VGH5, VGE5, VYD, VHD, VLD - VPA, VPAME - TNR - ANR
en
7